7. Perform the density adjustment so that the obtained density is equal to the reference density. To increase (decrease) the print density Increasing the density: Turn 1VR1 (22 V ADJ.) of the power block clockwise. Decreasing the density: Turn 1VR1 (22 V ADJ.) of the power block counterclockwise. Adjust 1VR1 until the obtained density becomes equal to the reference density and print the test pattern (LINEAR STEP). 8. When message �Test1 to Test6/7 Exit� is displayed with the Arrow key ( � ) pressed, select �Exit� and press the ENTER key. n In steps 6 and later, the test pattern is printed only using one sheet of paper.