The refrigerator needs about 6 hours at normal ambient temperature to reach 6 °C in the storage compartment.
8. Reversing the door hang, (Fig. 7)
Lay the appliance on its back. Remove the 8 screws (1). Remove the door, together with the two hinges (2), from the housing. Remove the two cover caps (3) from the housing and place them in the open hinge holes in the housing. Place the bottom righthand hinge in the top left of the door and the top righthand hinge in the bottom left of the door and hang the door on its hinges in the open cover cap holes in the housing. Secure the hinges and cover caps with the 8 screws. Check that the door closes easily and is sealed properly.
5.1. Temperature regulation
The temperature of the miniCool is pre-setted to approximately +5 °C at +25 °C ambient temperature. If the ambient temperature will change, the inside temperature will also be changed.
Figure 5.
Do not overfill the appliance. It is advisable to leave some space between the products in the cabinet to ensure efficient and even cooling. If the shelves are packed too tightly there may be unacceptable temperature variations.
6. Useful suggestion
Figure 7.
9. Replacing the decorative door panel, (Fig. 8-10)
Frost will gradually form on the cooling fins and it must not be allowed to become too thick since it acts as an insulator and interferes with the cooling. The frost will melt and the defrost water will run through the drain tube from the drip channel into an evaporating vessel located at the bottom rear of the refrigerator. (Fig 6) The defrost water will evaporate automatically into the circulating air and the vessel will not need emptying manually. If we want to switch off the unit, turn the main switch to "0", disconnect the refrigerator from the electricity supply and leave the cabinet door open. After defrosting the cabinet interior should be wiped out with a clean, damp cloth.
7. Defrosting, cleaning and maintenance
Remove the two screws (1) from the upper hinge of the door. Pull the door together with the hinge away from the housing and up off the lower hinge bolt (2-3). Remove screws (4) and pull off the frame edge (5). Slide the decorative panel (6) out of the door frame and insert the new panel (7), so that the upper edge of the panel runs exactly parallel to the upper edge of the frame. A new panel can be inserted more easily into the upper edge of the frame when the two corners are cut off by approx. 5 x 5mm (8). Put the frame edge (5) back in place and secure with screws. Place the door on the lower hinge (9), slot the upper hinge into the opening, press together with the door against the housing and secure with the two screws (11).
