Handling of HDD The following precautions should be taken when handling HDD.
1. Never give an impact to HDD. (Even a drop from 1cm height can be a cause of HDD failure.) 2. When placing HDD on a workbench, provide a mat on a bench for shock absorption and anti-static purposes. 3. When installing HDD, release it from your hands only after confirming that it is fully set on the chassis. 4. Avoid stacking up HDD. 5. HDD is unstable and easy to fall. Do not stand it on its side face. 6. When handling HDD, hold its side faces to avoid static hazard. 7. Do not place HDD on its wrapping bag after removal. (Prevention of static hazard) 8. Use a screwdriver with low impact and anti-static features. 9. To replace HDD, remove the vertical short-circuit pin. (Keep the horizontal short-circuit pin in its place)
Note: When replacing HDD, please make the rear jumper slave configuration. (same configuration as HDD to exchange)
8.12. The Rear panel 1. Remove the Fan Motor connector.
2. Remove the 8 screw (A) and 1screw (B). 3. Remove the 2 tabs and remove the Rear panel.
