PANASONIC DMC-LX1EG VOLUME 1
Manual de Servicio

8.4.

Disassembly Procedure for the Lens

NOTE: When Disassembling and Assembling for the Lens 1. To prevent the lens from catching the dust and dirt, perform the following procedures with the CCD unit is installing. Disassembling procedures for the CCD unit, refer to item 8.6. 2. Take care that the dust and dirt are not entered into the lens. In case of the dust is putted on the lens, blow off them by airbrush. 3. Do not touch the surface of lens. 4. Use lens cleaning KIT (BK)(VFK1900BK). 5. Apply the grease (VFK1829) to the point where is shown to" Grease apply" in the figure. When the grease is applied, use a toothpick and apply thinly.

8.4.1.
1. 2. 3. 4. 5.

Removal of the Zoom Motor Unit and Master Flange Unit

Remove the solders (2 points). Remove the lock (4 points). Unscrew the 5 screws (A). Remove the Zoom Motor Unit to the indicated by arrow. Remove the master flange unit.

Fig. D14

NOTE: (When Assembling) Confirm the contents as shown below. � Condition of the screw is tightened. � Assembling condition of mechanism parts (distortion, space etc.) � Dust and dirt of the lens, display condition of the LCD (gradient etc.) � Dust and dirt of the LCD

29