PANASONIC DMC-LS80P VOLUME 1
Manual de Servicio

3.4.2.

INITIAL SETTINGS:

When you replace the Main PCB, be sure to perform the initial settings after achieving the adjustment by ordering the following procedure in accordance with model suffix of the unit. 1. IMPORTANT NOTICE: Before proceeding Initial settings, be sure to read the following CAUTIONS.

2. PROCEDURES: � Precautions: Proceed the picture back up from the unit. (Refer to above "CAUTION 2") � Preparation. Set the Recording mode to "Normal Picture Mode". Set the Recording/playback switch to �[ Recording mode ] (camera mark Turn on the power and then press the [MODE] button. Select the �NORMAL PICTURE MODE" using �[ UP ] / [ DOWN ] Press [ MENU/SET ] button, then turn the power off. � Step 1. The temporary cancellation of initial setting: (UP))�.

of Cursor button�.

Set the Recording/playback switch to �[ Recording mode ] (camera mark

(UP))�.

While keep pressing [ E.ZOOM ], [ MENU ] and �[ UP ] of Cursor button� simultaneously, turn the Power on. � Step 2. The cancellation of initial setting: Set the Recording/playback switch to �[ Playback (Down) ]�. Press [ E.ZOOM ], [ MENU ] and �[ UP ] � Step 3. Turn the Power on: of Cursor button� simultaneously, then turn the Power off. (UP))�, and then turn the Power on.

Set the Recording/playback switch to �[ Recording mode ] (camera mark � Step 4. Display the INITIAL SETTING: While keep pressing [ MENU ] and �[ RIGHT ]

of Cursor button� simultaneously, turn the Power off.

8