PANASONIC DMC-FX33P VOLUME 1
Manual de Servicio

8.4.

Disassembly Procedure for the Lens

4. Turn the drive gear to the indicated by arrow fully.

NOTE: When Disassembling and Assembling for the Lens 1. To minimize the possibility of the CCD being dirt, perform disassemble and/or assemble under the condition of the CCD is being mounted. Disassembling procedures for the CCD unit, refer to item 8.6. 2. Take care that the dust and dirt are not entered into the lens. In case of the dust is putted on the lens, blow off them by airbrush. 3. Do not touch the surface of lens. 4. Use lens cleaning KIT (BK)(VFK1900BK). 5. Apply the grease (VFK1829) to the point where is shown to" Grease apply" in the figure. When the grease is applied, use a toothpick and apply thinly. 6. When repair the fixed frame, drive frame and direct frame, must be unit exchange.

8.4.1.

Zoom Motor Unit, Master Frange Unit and 1st Lens Frame/2nd Lens Frame Move Unit

1. Unscrew the 4 screws (A). 2. Remove the zoom motor unit to the indicated by arrow. 3. Move the master frange unit to the indicated by arrow.

5. Push the 1st lens frame unit to the indicated by arrow from lens side, and then remove the unit of 1st lens frame/2nd lens frame move unit from the fixed/drive/direct frame unit.

25