|
No hay comentarios de productos.
Section
Before You Start
01
English
! A few seconds after turning the ignition switch to on or off, the front panel automatically moves. When this happens, your fingers may become jammed in the panel, so keep your hands away from it. ! When removing the front panel, be sure to hold the corrugated release button on the rear of the front panel while pulling.
2 Replace the front panel by clipping it into place.
Removing the front panel
1 Press EJECT to open the front panel. If a disc has been inserted to this unit, pressing and holding EJECT enable to open the front panel without ejecting a disc.
Resetting the microprocessor
The microprocessor must be reset under the following conditions: ! Prior to using this unit for the first time after installation ! If the unit fails to operate properly ! When strange or incorrect messages appear on the display % Press RESET with a pen tip or other pointed instrument.
2 Press the release button, slide and remove the front panel toward you. Take care not to grip it too tightly or to drop the front panel and protect it from contact with water or other fluids to prevent permanent damage.
RESET button
Release button
3 Put the front panel into provided protective case for safe keeping.
Switching the DSP setting mode
This unit features two operation modes: the 3way network mode (NW) and the standard mode (STD). You can switch between modes as desired. Initially, the DSP setting is set to the standard mode (STD).
En
Attaching the front panel
1 Make sure the inner cover is closed.
7
|
