PIONEER DEH-1850/XU/ES
Manual de Usuario

Section

03

Operating this unit Basic Operations
Turning the unit on and selecting a source
You can select a source you want to listen to. To switch to the built-in CD player, load a disc in the unit (refer to the next page). % Press SOURCE to select a source. Press SOURCE repeatedly to switch between the following sources: Built-in CD playerTuner When you select a source, the unit is turned on.
Notes ! When no disc has been set in the unit, the source will not switch to the built-in CD player. ! When this units blue/white lead is connected to the vehicles auto-antenna relay control terminal, the vehicles antenna extends when this units source is turned on. To retract the antenna, turn the source off.

3 To perform manual tuning, briefly press c or d. 4 To perform seek tuning, press and hold c or d for about one second and release. The tuner will scan the frequencies until a broadcast strong enough for good reception is found.

# You can cancel seek tuning by briefly pressing c or d. # If you press and hold c or d you can skip stations. Seek tuning starts as soon as you release the button.

Storing and recalling broadcast frequencies
If you press any of the preset tuning buttons 16 you can easily store up to six broadcast frequencies for later recall with the touch of a button. ! Up to 18 FM stations, six for each of the three FM bands, and six AM stations can be stored in memory.

Adjusting the volume

% Use VOLUME to adjust the sound level.

Turning the unit off
% Press SOURCE and hold until the unit turns off.

% When you find a frequency that you want to store in memory, press one of preset tuning buttons 16 and hold until the preset number stops flashing. The selected radio station frequency is stored in memory. The next time you press the same preset tuning button the radio station frequency is recalled from memory.

Tuner
Listening to the radio
Important If you are using this unit in North, Central or South America, reset the AM tuning step (see Setting the AM tuning step on page 9).

Tuning in strong signals
Local seek tuning lets you tune in only those radio stations with sufficiently strong signals for good reception. % Press LOCAL/BSM repeatedly to turn local seek tuning on or off. When local seek tuning is on, LOC appears in the display.

1

Press SOURCE to select the tuner.

2 Press BAND to select a band. Press BAND until the desired band (F1, F2, F3 for FM or AM) is displayed.

6

En