Removal procedure
Remove the belt 1 from the conversion gear. Remove the conversion gear 2 from the conversion gear shaft.
2.
1) 2) 3)
Attachment procedure
Apply grease to the conversion gear shaft. Amount of grease: a ball of grease of 1.0 mm diameter Install the conversion gear 2 in the conversion gear shaft. Hook the belt 1 on the conversion gear in a slant angle and install it by rotating the conversion gear with fingertip.
BELT Key Points in Re-assembling
2 Conversion gear
Hook the belt 1 on the conversion gear in a slant angle. Do not remove the capstan motor assy.
1 Belt
The belt must not be twisted.
Conversion gear shaft
Apply Grease Points to be noted
Apply grease when installing it. Amount of grease: a ball of grease of 1.0 mm diameter Apply grease Conversion gear shaft
The belt must not override on the capstan motor block assy.
� The belt must not override on the capstan motor block assy. � When installing the belt, the belt must not have any twisting, dust, scar or grease must not be splashed on belt.
