SONY DCRDVD92
Manual de Servicio

6) After setting the picture frame, if the [End] button is clicked, �5. Color Reproduction Adj.� is executed. The following message is displayed, and then adjust the burst position of the vectorscope.

7) If the [OK] button is clicked, the following message is displayed, and then adjust the luminance point of each color using the [Up]/[Down] button on the screen. After the adjustment finished, click the [End] button.

R-Y MG

R

YE B-Y

8) After the adjustment, if the [End] button is clicked, the following messages are displayed in the order given below. Then, change the chart in accordance with the message.

G

B

CY
Burst position

R-Y
Burst position

R

MG

YE B-Y G B

9) After the setting, if the [OK] button is clicked, the adjustment items �6. AWB Standard Data Input� and �7. LV Standard Data Input� are executed. 10) Upon successful completion of the �7. LV Standard Data Input�, the following message is displayed during the execution of �8. AWB Adj.�. During the execution, the following messages are displayed in the order given below. Place or remove the filters on the lens in accordance with the messages.

CY

Fig. 6-1-14

DCR-DVD92/DVD92E/DVD103/DVD602/DVD602E/DVD653/DVD653E

6-30