AIWA CXNA111
Manual de Usuario

POWER b�

1 Press TUNER/BAND desired band.

repeatedly
AM

to select

the

The unit can store a total of 32 preset stations. When a station is stored, a preset number is assigned to the station, Use the preset number to tune in to a preset station directly.

r---1
When TUNER/BAND power is turned on directly.

FM ~

is pressed

while the power

is off, the

7 Press TUNER/BAND to select a band, and press DOWN or UP to select a station. 2 Press 11 SET to store the station.
A preset number beginning from 1 in consecutive each band is assigned to the station. Preset number order for

To select a band with the remote control Press BAND while pressing SHIFT,

2 Press <4

DOWN or ®> UP to select a station.

Each time the button is pressed, the frequency changes. When a station is received, �TUNE is discrlaved for 2 seconds. During FM stereo reception, ([[0}1] is d~sp~yed. ([[011) TUNE

3 Repeat steps 1 and 2.
The next station will not be stored if a total of 32 preset stations for all the bands have already been stored.

To search for a station quickly (Auto Search)
Keep to change

m
starts stops. �FULL! is displayed stations. if you attempt to store more than 32 preset very weak Use the remote control to select the preset number directly

DOWN or >
rapidly.

UP pressed
manually,

until the frequency the search +

After tuning

in to a station, press

To stop the Auto Search

DOWN or ~
with

UP.
q

The Auto signals.

Search

may not stop

at stations

When an FM stereo broadcast

contains noise

Press MONO TUNER on the remote control while pressing SHIFT so that �MONO� appears on the display. Noise is reduced, although reception is monaural. To restore stereo reception, repeat the above so that �MONO disappears.

1 Press BAND while pressing band. preset number.
Example: To select preset number To select preset number

SHIFT to select a

2 Press numbered buttons O-9 and +1 O to select a

To change the AM tuning interval
The default setting of the AM tuning interval is _10 kHz/step. If you use this unit in an area where the frequency allocation system is 9 kHz/step, change the tuning interval. Press POWER while pressing P. To reset the interval, repeat this procedure.

20, press +10, +10 and 0, 15, press +10 and 5,

Selecting a preset number on the main unit Press TUNER/BAND to select a band. Then, press b PRESET
repeatedly. Each time k is selected.

PRESET is pressed,

the next ascending

number

When the AM tuning interval is changed, all preset stations cleared. The preset stations have to be set again.

m

are

To clear a preset station
Select the preset number of the station to be cleared. Then, press 9 CLEAR, and press 11 SET within 4 seconds. The preset numbers of all other stations in the band with higher numbers are also decreased by one.

10 ENGLISH