ONKYO CR-715
Manual de Usuario

Using the Timers�Continued

7

If you selected Once, use the Previous and Next [ ]/[ ] buttons to select the day, and then press [ENTER]. You can select: SUN, MON, TUE, WED, THU, FRI, or SAT.

11

Use the Previous and Next [ ]/ [ ] buttons to specify the Off time, and then press [ENTER].

TIMER indicator

8

If you selected Every, use the Previous and Next [ ]/[ ] buttons to select the day, Everyday, or Days Set, and then press [ENTER]. You can select the following:
MON TUE WED THU FRI

Underscore indicates timer programmed for recording

Number of programmed timer

12

Use the Previous and Next [

]/

[ ] buttons to specify the CD receiver�s volume level, and then press [ENTER].

SUN

Days Set

Everyday

SAT

9

If you selected Days Set, use the Previous and Next [ ]/[ ] buttons to select the �rst day, and then press [ENTER].

The default setting is 10. If you want to use your normal volume level setting for the timer, press the Previous [ ] button repeatedly until �TimerVol.Off� appears on the display. In this case, the timer will use the volume level that was set before the CD receiver was set to Standby.

Use the Previous and Next [ ]/ [ ] buttons again to select the last day, and then press [ENTER].

13

Press the [STANDBY/ON] button to set the CD receiver to Standby. Notes: � Be sure to set the CD receiver to Standby, otherwise the timed operation will not work. � While a timed operation is in progress, you can cancel it by pressing the [TIMER] or [SLEEP] button. � While timed recording is in progress, the output of the CD receiver is muted. To hear what�s being recorded, press the [MUTING] button. Press it again to mute the CD receiver. � Memory, random, and 1-Folder playback cannot be used with the timers.

You can select only consecutive days.

10

Use the Previous and Next [ ]/ [ ] buttons to specify the On time, and then press [ENTER].

You can also use the remote controller�s number buttons to enter the time. For example, to enter 7:29, press [>10], [0], [7], [2], and [9]. Notes: � Once the On time is set, the Off time is automatically set to one hour later. � To ensure that the �rst few seconds of a program are recorded when using timer recording, set the On time slightly ahead of the program�s start time (about 1 minute).

To return to step 1 and start timer programming all over again, press the [MENU/NO] button at any point in this procedure.

51