PANASONIC CQ-FX321
Manual de Usuario

Anti-Theft System
This unit is equipped with a removable face plate. Removing this face plate makes the radio totally inoperable. r Removable Face Plate Case

E N G L I S H 18

Place Removable Face Plate into Case
q Switch off the power of the unit. w Remove the removable face plate. (a Page 22) e Gently press the bottom of the case and open the cover. Place the face plate into the case and take it with you when you leave the car.

Cautions: ¡This face plate is not water-proof. Do not expose it to water or excessive moisture. ¡Do not remove the face plate while driving your car. ¡Do not place the face plate on the dashboard or nearby areas where the temperature rises to high levels.

Install Removable Face Plate
q Fit the face plate with its right or left hole on one of the pins provided on the main unit. w Fit the other hole on the other pin applying slight pressure. e Move the face plate up and down a few times to make sure it is secure. Then close the front panel and press down the right side of the face plate until it clicks into place.

Panel Removal Alarm
This alarm sounds to warn you not to forget to remove the panel before leaving your car.
SEL
PRG AUTO·P
REMOTE

CQ-FX421N
PTY
PWR

OPEN

VOL

BAND

MONO/LOC

TUNE
TRACK

SOURCE
CASSETTE RECEIVER WITH CHANGER CONTROL
CT
EON EPTY E CT

S�HDB

DISC

RANDOM

SCAN

REPEAT

REG

TA

q Press and hold [SEL] to change to display control mode. (�PATTERN� is displayed.) (a Page 8) w Press [SEL]. �LED On� or �LED OFF� is displayed. e Press [] TUNE] or [[ TUNE] to turn the Panel Removal alarm on or off (LED ON or OFF).

DISP

1 MTL

NR 2

3 TPS

4

5 B·S

REP 6

AF SUB·W

Display

Panel Removal Alarm ON OFF

CQ-FX421/FX321N

23