CP-ST3
BEFORE USE
Thank you for purchasing the CP-ST3 Pioneer speaker stand. This speaker stand should only be used for a Pioneer speaker system. ÷ Read this operating guide carefully before setting up your speaker system, and then save it for future reference. ÷ Before setting up your speaker system, a thorough reading of the operating guide is recommended.
Assembly
Tools required: A medium-size Phillips screwdriver and the supplied hexagonal wrench.
Note: Assemble the stand on a level surface, preferably covered with carpet. Follow the instructions below to assemble the stand. 1 Insert the tubular supports into the mount, and fix using the two M4x8 (3/16x5/16in) screws from the back of the supports. 2 Insert the tubular supports into the holes in the base. Use the hollow bolt to fix the left-hand support; the speaker cable passes through the hole in the bolt. Use the ordinary bolt to fix the right-hand support. Use the supplied hexagonal wrench to tighten the bolts. * Be careful to use the correct bolts for the left and right supports. M4x8 (3/16x5/16in), two fixing screw (BXZ40P080FZB)
CAUTIONS
÷ Fix the speaker system to the stand using the fixing screws supplied. ÷ Do not place the stand on an unstable and/or sloping surface. Otherwise, the stand and speaker may fall and cause injury. ÷ Do not mount any speaker other than the specified Pioneer speaker on this stand. Otherwise, the stand may collapse and/ or the speaker may fall and cause injury. ÷ When moving the speaker and stand, first remove the speaker from the stand, and then move the stand, holding the tubular columns. ÷ This stand can hold a speaker with the maximum weight of 1.0 kg (2 lb 3oz).Mounting a speaker heavier than the maximum weight may cause the stand and speaker to collapse and be damaged.
Tubular supports
You can mount the HTZ-ST7 Pioneer satellite speaker on this stand.
Tubular supports
Names of Parts
( )The replacement part numbers are shown in parentheses.
Assembled CP-ST3 speaker stand
Tubular supports (SNK2365) Base Assy
3. Insert the speaker cable (supplied with HTZ-ST7) into the bottom of the left-hand support and pass it through the support, until it appears at the mount end. 4. Pass the speaker cable through the mini-stand (supplied with HTZ-ST7), then fix the mini-stand to the mount using the doublesided adhesive tape and mounting screw M3x10 (1/8x3/8 in).
