Message
Disc is full. (No area for new recording) You cannot record on the disc as Power Calibration Area is full. This disc is already finalized.
Solution
Insert the recordable disc with enough recording space. Insert a new disc. Release the finalizing for this disc. Repeat the same operation.
Error No.
30
Error Description
No avilable recording space.
Priority
10
35 36 37
PCA is Full. (in REC start) It is finalized. (Video Format Disc) Access to Memory Area range outside. Sector Address is wrong. BUP writing error of chapter editing. Its recording capacity has been reached.
4 8 9
Can not record on this disc. You cannot record more than 49 titles on the disc.(The maximum is 49.)
38 39
Delete unnecessary titles.
43
You cannot record more than Delete unnecessary chapter 254 chapters on the disc.(The marks. maximum is 254.) This program is not recordable You cannot record copy in +VR mode. prohibited programs. The disc has a different menu layout. (Set �Replace Disc Menu� to ON to rewrite the menu.) Set �Replace Disc Menu� to �ON� to rewrite the menu,after that you will record to.
44 45
The 254 chapter has been reached. During the CGMS picture input. Trying to record onto the +VR formatting disc that had been recorded by the other recorder.
10 12
46
7
If an error occurs during the timer recording, one of the following error numbers (40 to 42) or the above error messages (error number: 1 to 39) is displayed on the recording menu after timer recording. (Once the screen of the program line is exited, the program line for the error will be cleared.) (No Error Message is displayed for the error No. 40 ~ 42.)
Timer Programming
2. 3. 4. 5. 6. 7. 8.
---------------
The speed mode changes to the error number.
A program with the error number is grayed out and asterisked on the timer programming list.
Message
Solution
- Set the timer programming correctly. - Set the timer programming before the start time. Turn the power on and set the clock correctly then set timer programming again. Insert the recordable disc.
Error No.
40
Error Description
- Some portion has not been recorded because of program overlapping. - Recording did not start at the start time.
