STC POS GEAR SL
Note: DO NOT remove the STC POS Gear SL together with the STC Motor SL Ass�y (Stocker) (M3), always replace it alone. If they are removed at the same time and the gear in the stocker height becomes out of position. 1 washer 2 STC POS gear SL POSITIONING OF THE STC POS GEAR SL REQUIRED Note: Assemble the STC POS gear SL so that the mark c on the STC POS gear SL meets the mark b on the MA chassis SL S ass�y. c b
STC POS gear SL
MA chassis SL S ass�y
LDG PLATE CAM SL
1 washer 2 LDG plate cam SL Note: Never use nail when turning the emergency gear SL.Otherwise, the gear tooth may be broken. (Fig. G. 2) emergency gear SL (Fig. G. 1) d
INSTALLING THE LDG PLATE CAM SL
POSITIONING OF THE LDG PLATE CAM SL IS REQUIRED.
(1) Turn the emergency gear SL in the direction of the arrow as shown Note: Never use nail when e in Fig. G. 1 until it stops. turning the emergency (2) Assemble LDG plate cam SL so that the center of the LDG plate cam gear SL. SL, mark d on the LDG plate cam SL and the center of the shaft are Otherwise the gear aligned on one line as shown in Fig. G. 2. tooth may be broken. (3) Turn the emergency gear SL in revers until the marks d , e on LDG plate cam SL are almost aligened as shown in Fig. G. 3. (This operation is required to return to the mechanism in standby state.) emergency gear SL