With regard to the protection against overheating of surrounding furniture surfaces this appliance corresponds to type Y. This appliance or the built-in cupboard for the appliance respectively may be located with the rear wall and one side wall to whatever high walls or furniture respectively and with the other side to another appliance or furniture of the same height as this appliance.
Hob installation
D Cut out the worktop with the cut--out size as stated. The toleranced sizes must not be exceeded.. Saw exactly at the marking line. Recommendation: Mark the cut--out with a steel needle.Cover-glue the line in order to avoid splintering of the coating when cutting. With tiled worktops the grooves within the contact area of the cooking area must completely be filled up with groove material. Clean the worktop in the cut--out section From the top lay the cooking area into the cutoutand adjust concentrically. 4 holes in the bottom of the build--in case are provided for the screws of the fitting plates. At first screw on the fitting plates by a screwdriver and afterwards regularly tighten the plates alternatively and diagonally offset, until the frame of the cooking area is perfectly laying on the worktop. A too strong and one--sided tightening is to be avoided! Electric screwdrivers or pusher airscrews to be exclusively used with slip clutch (setting value 1 -- 1.1 Nm).4 Check the seal in the supporting frame for perfect seating and gapless support. Please do not apply further silicone sealing matter as this will complicate the removal of the hob if servicing is necessary.
R5
