CONNECTING THE CLON99-BK SMARTLOADER
Optimum Performance of the Clon99-BK SmartLoader box is obtained by plugging it into an ITV set that is already turned on.
BEGIN
Clon99-BK SmartLoader Connection
1
Power button on the front of an ITV.
Press the POWER button to turn the ITV ON. Plug one end of the cable into the jack provided on the Clon99-BK SmartLoader. Plug the other end into the jack provided on the back of the TV. The TV�s jack is next to the Antenna Input terminal and may be labeled various ways such as; Smart Port, Clone Port, etc. Push the Slide Switch to the ON position. The red LED should light. (If the TV is turned off, it should turn on within 15 seconds.) Within 20 seconds, the Clon99BK SmartLoader on-screen display should appear. If the display does not appear, check the connections and push the Slide Switch to the ON position again. If there is still no response from the SmartLoader, replace its 9-volt battery. Once the Clon99-BK SmartLoader on-screen display appears, press the POWER button on the RG4172BK (T374AH) Remote Control. The SmartLoader Setup Menu should appear.
POWER
Clon99-BK SmartLoader
EXTERNAL SPEAKER 75� ANT/ CABLE
SMART PLUG
2
EXTERNAL SPEAKER 75� ANT/ CABLE
Rear jack panel of ITV
SMART PLUG
3
Cable
4
LED
Clon99-BK SmartLoader ON/OFF slider switch
5
Clon99-BK SmartLoader On-Screen Display
6
Clon99-BK SmartLoader Setup Menu Press the POWER button on the remote control.
CH A/
PHILIPS SMARTLOADER 99
Copyright PCEC 1999 System Version D.0 PN 3135 019 01681
Philips SmartLoader 99 System Version D.0 1 - Read TV
RLIC A L L E GHT
SLEE
P
SELECT
M
CH
TE
VO
L
MU
D C B E
ET RES
2 - Write TV With Settings 3 - Write TV Without Settings 4 - Erase SmartLoader Memory 5 - System Test 6 - Exit SmartLoader