WHIRLPOOL CGL1100ADW
Manual de Usuario

ABOUT YOUR COOKTOP
IGNITION SYSTEM
Your cooktop will feature either pilot ignition or pilotless ignition. If the gas supply to the range is turned off, be sure all controls are set in the OFF position before re-supplying gas to the appliance.

5

HOW TO LIGHT SURFACE BURNERS
CAUTION: If the flame should go out during a cooking operation, turn the burner off. If gas has accumulated and a strong gas odor is detected, open a window and wait 5 minutes for the gas odor to disappear before relighting burner. To prevent damage to the cooktop or pan, never operate surface burner without a pan in place, never allow a pan to boil dry and never operate a surface burner on HIGH for extended periods of time.

Pilot Ignition

When the range is first installed, the pilots may be difficult to light due to air in the gas line. To bleed off air from the line, hold a lighted match next to the burner and turn knob on. When the burner lights, turn the knob off and proceed as directed below. To light pilot: Raise cooktop and hold a lighted match near the pilot ports. There are two pilot ports.

To light surface burner:
1. Place a pan on the burner grate. NOTE: The burner flame may lift off the burner head and a �roaring� sound may be heard if a pan is not placed on the grate before lighting the burner. 2. Push in and turn knob to the LITE position. Pilotless ignition models only: A clicking sound will be heard and the burner will light. When one burner is turned on, all ignitors will spark.

Pilotless Ignition
Pilotless ignition uses a spark from the ignitor to light the burner. There are two ignitors for conventional surface burners. Once the burner lights, turn the knob to the desired setting. The clicking sound will not stop until the knob is turned from the LITE position. Once the burner lights, turn the knob to the desired setting. The clicking sound will not stop until the knob is turned from the LITE position. In the event of a power failure, the surface burner can be manually lighted. Be sure all controls are in the OFF position. Hold a lighted match to the desired surface burner head. Push in and turn knob to the LITE position. The burner will then light. Adjust the flame to the desired flame size.
RIGHT REAR

INTERNATIONAL SYMBOLS

3. After the burner lights, turn the knob to the desired flame size. Pilotless ignition models only: The ignitors will continue to spark until the knob is turned from the LITE position. Adjust the flame size so it does not extend beyond the edge of the cooking utensil. This is for personal safety and to prevent possible damage to the appliance, pan, or cabinets above the appliance. This also improves cooking efficiency.