� DIAL POINTER SETTING
Note : Follow the installation procedure in the numerical order given.
Back plate 4 Set the right side edge of Pointer to the scratched line on Cabinet (front). Cabinet (front) Pointer Scrached line
Set Pointer to "Cabinet (front)" as shown in the figure.
Cabinet (front) Pointer
3Screws (+BVTP 3X10)
1
2
Cabinet (rear) ASSY
7
6Turn knob (tune) fully in the direction of the arrow as shown in the figure.
Cabinet (front)
ECM101
5Set the leads from microphone(ECM101) as shown in the figure.
