SHARP CDDP2500H
Manual de Servicio

SETTING CLOCK RESETTING THE MICROCOMPUTER
ditions: Press ON/STAND-BY button to enter the stand-by mode.

(Main unit operation)
q To erase all of the stored memory contents (clock and timer q If the display is not correct.

In this example, clock is set for the 24-hour (0:00) system. Reset microcomputer under the following con-

1

CD-DP2500H

2 Press the CLOCK button. settings, tuner and CD presets). 3 Within 5 seconds, press the MEMORY/SET button. q If the operation is not correct.
1 Press ON/STAND-BY button to enter the stand-by mode. 4 2 Whilst pressing down / button and the X-BASS display mode.
second. (0:00 23:59)

Press TUNING/TIME ( or ) button to select the time

�0:00� �The 24-hour display will appear. button, hold down the ON/STAND-BY button for at least 1

�AM 0:00� �The 12-hour display will appear. q �CLEAR AL� will appear. (AM 0:00 PM 11:59) Caution: (AM 12:00 PM 11:59) memory including clock timer settings, tuner and

�AM 12:00� �The 12-hour display will appear. q The operation explained above will erase all data stored in stalled or it has been reset.

q Note that this can only be set when the unit is first inCD presets.

5 Press the MEMORY/SET button. 6 Press TUNING/TIME ( or ) button to adjust the hour.
vance the time by 1 hour. Hold it down to advance continuously. automatically to �PM�.

q Press the TUNING/TIME ( or ) button once to ad-

q When the 12-hour display is selected, �AM� will change

7 Press the MEMORY/SET button. 8 Press TUNING/TIME ( or ) button to adjust the min-

OPERATION MANUAL

�8�
(Seconds are not displayed.) And then the clock display will disappear after a few seconds.

utes. q Press the TUNING/TIME ( or ) button once to advance time by 1 minute. Hold it down to change the time in 5 minute intervals. q The hour setting will not even if minutes advance from �59� to �00�.

9 Press the MEMORY/SET button.

q The clock starts operating from �0� second.

To see the time display:

Press the CLOCK button. q The time display will appear for about 5 seconds.

Note: q The clock display will flash on and off at push of the CLOCK button when the AC power supply is restored after a failure occurs or after the AC power lead is disconnected. If this happens, follow procedure below to change the clock time.

To change the clock time:

1 Press the CLOCK button.

2 Within 5 seconds, press the MEMORY/SET button.

3 Perform steps 6 9 above.

To change the time display mode:

Perform steps 1 2 in the section �RESETTING THE MI-

CROCOMPUTER�.

2 Perform steps 1 9 above.