Connecting Speakers
You can connect the speakers using the speaker cords.
1
2
3
1
2
3, 4
Vinyl-covered wire (not supplied) Red
Red
AM loop antenna (supplied) Black
Black Speaker cord (Supplied with Red Black your speakers)
Red
1 2
Connect the AM loop antenna to the AM LOOP terminals as illustrated. Turn the AM loop antenna until you have the best reception.
Right speaker
Left speaker
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. (The AM loop antenna must remain connected.)
1 2 3 4
Twist the core of the cord at the end of each cord, then remove the insulation. Open the speaker terminal. Insert the end of the speaker cord to the terminal. Match the polarity of the speaker terminals: Red (+) to red (+) and black (�) to black (�). Close the speaker terminal on the rear of the unit.
For better reception of both FM and AM � Make sure the antenna conductors do not touch any other terminals and connecting cords. � Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.
Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.
