JVC CA-HXZ10
Manual de Usuario

Common Operations
Turning On or Off the Power
To turn on the unit, press (or STANDBY/ON on the remote control) so that the STANDBY lamp goes off.
STANDBY

Setting the Clock
ECO

Before operating the unit any further, first set the clock built in this unit. �0:00� will flash on the display until you set the clock. � You can set the clock whether the unit is on or off. � If Ecology Mode is activated, you cannot set the clock while the unit is off.

On the unit ONLY:
To turn off the unit (standby), press STANDBY ECO (or STANDBY/ON on the remote control) again so that the STANDBY lamp lights up. � A little power is always consumed even while the unit is on standby. To switch off the power supply completely, unplug the AC power cord from the AC outlet.
When you unplug the AC power cord or if a power failure occurs The clock is reset to �0:00� immediately, while the tuner preset stations (see page 13) will be erased in a few days.

1

Press

CLOCK/TIMER.
CLOCK /TIMER

The hour digits start flashing on the display.

2

Turn ¢ / 4 to adjust the hour, then press SET/DISPLAY.
The minute digits start flashing on the display.

PRESET

SET /DISPLAY

NIN

Saving the Power Consumption while on Standby (Ecology Mode)
You can save the power consumption while the unit is turned off (on standby). � You can set Ecology Mode whether the unit is on or off.

To correct the hour after pressing SET/DISPLAY, press CANCEL/DEMO. The hour digits start flashing again.

CANCEL /DEMO

3
On the unit ONLY:
To activate the Ecology Mode, press STANDBY ECO ECO. �ECO� appears on the display for 2 seconds (and demonstration is canceled temporarily if you have pressed the button while the unit is off). � Each time you press the button, �ECO� and �NORMAL� appear alternately on the display. To deactivate the Ecology Mode, press ECO again. �NORMAL� appears (and demonstration starts if the unit is turned off).

Turn ¢ / 4 to adjust the minutes, then press SET/DISPLAY.

PRESET

SET /DISPLAY

To check the clock time while playing a source
Press and hold SET/DISPLAY. � Each time you press and hold the button, the source indication and the clock time alternate on the display.

T T U G U NIN G

When you turn off the unit with Ecology Mode activated �ECO� flashes on the display, and the clock time will not be shown while the unit is turned off.

To adjust the clock again
If you have set the clock before, press CLOCK/TIMER repeatedly until the clock setting mode is selected. � Each time you press the button, the clock/timer setting modes change as follows:
DAILY Canceled TIMER
(Daily Timer setting)

REC TIMER
(Recording Timer setting)

Clock setting

(The hour digits start flashing.)

9