AIWA CADW235
Manual de Usuario

Power Supply
OPE/BATl-

Connections
IMPORTANT Make sure that the AC cord is disconnected
q q

and batteries

are removed before connecting speakers. Do not connect other than the supplied speakers.

Position the speakers.
To couple with the speakers, slide each speaker down into the guide brackets on the center unit until the height is level with the unit. To separate the unit from the speakers, slide the speakers up and off, while pressing the speaker release knob.

The OPE/BATT to the unit.

indicator lights up while electric current flows

Connect the AC cord as illustrated

below.

Re I
knob I

Connect
~+@ supplied AC cord to an AC outlet

the speakers.
and

Connect the right speaker cord to the R terminals, the left speaker to the L terminals.

CAUTION Use only the supplied AC cord. Use with other cords may result in the risk of fire.

Connect the speaker cord with the white broken line to 0 and the other cord to O.

Open the lid of the battery compartment on the rear and insert eiaht R20 (size D) batteries, not sumiied, as illustrated below. ~hen close the lid. To switch from AC power supply to battery supply, disconnect the AC cord from the AC inlet.

When the OPE/BATT indicator becomes dim, the tape speed slows down, volume decreases, or sound is distorted during operation, replace the batteries. Notes on batteries To avoid damage frolm leakage or explosion, observe the following: Insert the batteries with the O and O marks correctly aligned. Do not mix different types of batteries or old batteries with new ones. When the unit is not to be used for a long period, remove the batteries. Never recharge the batteries, apply heat to them or take them apart. Remove dead batteries. If liquid leaks from the batteries, wipe thoroughly to remove.
q q q q q

ENGLISH

3