CROSSLEE C603MElectricFire
Manual de Usuario

Before You Start
Please read these instructions carefully before you start installation. Check the pack and make sure you have all of the parts listed on page 2. When you are ready to start, make sure that you have the appropriate tools to hand, plenty of space and a clean dry area for installation. Check that the supply voltage on the rating label is in accordance with your electricity supply. WARNING THIS APPLIANCE MUST BE EARTHED ! IMPORTANT: If a replacement plug is required, the existing plug may be cut off. Please dispose of plug carefully and follow the manufacturers instructions when fitting the new plug. If required, a 15- amp plug may be used. If the supply cord is damaged, the manufacturer�s service agent or a similarly qualified person must replace it in order to avoid a hazard. FLUE: when fitted into a chimney opening, THE FLUE MUST BE BLOCKED to prevent any draught affecting the operation of the heater fan unit. (I.E. a strong draught up the chimney will cause intermittent operation of the overheat limit switch.) DO NOT INSTALL APPLIANCE IN AN EXISTING CHIMNEY OPENING UNTIL THE FLUE IS BLOCKED. DO NOT use the heater in the immediate surrounds of a bath, shower or swimming pool. DO NOT locate this appliance on a thick pile carpet. DO NOT place clothing or objects immediately in front of the heater outlet. It may cause overheating or cause objects to ignite. DO NOT locate or install immediately below a socket outlet. DO NOT leave children unsupervised near the appliance when in use. This appliance is fitted with a moulded plug supplied with a 13- Amp fuse. Always replace the 13- Amp fuse with one approved by ASTA to the current issue of BS 1362. The fuse cover is to be re-fitted after changing the fuse. If the fuse cover is lost, do not use the plug. Replacement fuse covers may be obtained from a reputable electrical spare retailer. In order to achieve the realistic flame effect and provide efficient heating, fans are used within this appliance. There may, as a result, be some residual noise when these are in operation � this is normal. Please retain these instructions for future reference! 3
110803