Using the Optional SP01 Shock-Mount
Using the Optional SP01 �Spider� Shock-Mount
For additional isolation, the C03 can be fitted on the optional SP01 �Spider� shock mount. Follow the steps below the to install the SP01. � First, screw the SP01 shock mount onto your mic stand or boom arm. If you�re using a US 5/8� mic stand or boom, remove the Euro adapter. Remove the C03 swivel mount by rotating the threaded collar counterclockwise as shown in figure 1. Install the C03 into the SP01 by fitting the microphone into the center of the web, positioning the C03 onto the bottom mounting plate. Secure the SP01 by reinstalling the threaded collar, rotating clockwise until tight. (Figure 2) � Now, loosen the thumb screw to adjust the angle of the microphone and position the C03 to the desired location. Once set, tighten the thumbscrew to secure the microphone in place. Note: Be careful not to cross thread or over tighten the threaded collar or thumb screw.