HUSQVARNA BZ34C
Manual de Usuario

Deck Leveling Combi Deck Locate the three deck leveling blocks from the loose parts.

Deck Leveling Block Raise the front of the deck and position the blades so they are parallel with the sides of the unit. Place one (1) height block under the front of the center blade on the mower deck. The blade tip should rest on the lower level of the spacer block (single hole level). Raise the rear of the deck and place one spacer block under the rear of each outer blade set at the higher level of the spacer block (dual hole level). This will put the deck at a slight angle tilting slightly lower toward the front. The deck will be set at 5.7 cm (2.25�) with the correct pitch. 2 Lower the deck lift lever to 5.7 cm (2.25�). The lift lever may have to be held down to prevent spring back. Connect the chains to the deck. Make sure to remove all slack from the chains by holding the mounting hardware toward the bottom of the slot while tightening the bolts on the deck. Remove the deck leveling blocks and verify the height is correct and all four (4) chains are tight. 1 2

Adjust Deck Using Deck Leveling Blocks 1. Front Block 2. Rear Block

1

Deck Lift Lever 1. Deck Height Adjustment Plates 2. Lift Lever

4 1150244-26 English