2-1. Board Removal
IDC connectors 1. With the computer powered off, release the catches on both sides of the computer housing cover with fingers and slide the cover out.
Computer Cover
SDDI interface board 1. With the computer powered off, release the catches on both sides of the computer housing cover with fingers and slide the cover out. (Refer to step 1 in the removal of �IDC connectors�) 2. Remove a screw fixing the SDDI interface board (into the lowest slot), and pull out the board.
Catch
2. Disconnect the 20-pin IDC connector from CN1 connector on the Link I/F TRAM board (IF-630). n Link I/F TRAM board (IF-630) is one of the daughterboard installing on SLOT 1 of the TRAM motherboard. 3. Remove a screw fixing the IDC connectors (into the third lowest slot), and pull out the IDC connectors (assembly).