� The electrical connection inside the turntable could be damaged When the turntable is switched on it does not start automatically and the motor makes a vibration � The Belt is too slack and does not produce the necessary friction with the pulley � The 3 stainless steel screws of the gold plated motor cover are too tighten When the turntable is switched on it does not start automatically � The Platter Bearing/Spindle system are very dirty making a too strong friction
� Contact assistance �
your
dealer
for
� Unscrew them enough to let the motor spins without making noise, they need just to be very gently screwed to the motor cover �
Troubleshooting
9
Bellavista Italian Prestige Rigid Turntable
F.A.Q. Adjustment
BELLAVISTA Turntable
ACTION
DUST COVER ADJUSTMENT FRICTION
DESCRIPTION
� The Dust Cover is hard or slack during open/close adjustment � The Turntable is not levelled
HOW TO ADJUST IT
� Adjust the single screw present on each hinge till you reach your proper wanted friction � With a spirit level, only level the Turntable Platter through its shelf layer eventually screwing its feet just for very fine adjust ment, take care of levelling the platter on its vertical and horizontal lines � Be sure that the turntable layer is enough solid and rigid to support the weight of the turntable easily � With the help of a �coin� screw clockwise or anti-clockwise the pulley�s internal cone to increase (clockwise) or decrease (anti-clockwise) the speed. Check the right speed with a proper stroboscope
LEVELLING THE TURNTABLE
� SPEED ADJUSTMENT ON THE ADJUSTABLE ALUMINIUM PULLEY
The Turntable is not levelled
� The aluminium adjustable pulley doesn�t spins at the right speed
VTA ADJUSTMENT
�
VTA tone arm is not adjustable
� The 3 arm board collar hex bolts are screwed into the collar too much and do not let the arm shaft gets in it; unscrew the hex bolts before inserting the arm � The tone arm shaft is too big to get into the collar; ask your local dealer to have a custom made collar may fit such arm � Once the proper height of the arm is been approximately reached, fix the shaft with just a hex bolt before screwing properly all the 3 hex bolts of the collar;