No hay comentarios de productos.
07
Cautions on use
Moving the player
If you need to move this unit, first remove the disc if there�s one loaded, and close the disc tray. Next, press � STANDBY/ON to switch the power to standby, checking that the POWER OFF indication on the front panel display goes off. Wait at least 10 seconds. Lastly, disconnect the power cord. Never lift or move the unit during playback � discs rotate at a high speed and may be damaged.
Condensation
If the player is moved suddenly from a cold place into a warm room (in winter, for example) or if the temperature in the room in which the player is installed rises suddenly due to a heater, etc., water droplets (condensation) may form inside (on operating parts and the lens). When condensation is present, the player will not operate properly and playback is not possible. Let the player stand at room temperature for 1 or 2 hours with the power turned on (the time depends on the extent of condensation). The water droplets will dissipate and playback will become possible. Condensation can also occur in the summer if the player is exposed to the direct wind from an air-conditioner. If this happens, move the player to a different place.
Place of installation
Select a stable place near the TV and AV system to which the unit is connected. Do not place the player on top of a TV or color monitor. Keep it away from cassette decks or other components easily affected by magnetism. Avoid the following types of places: � Places exposed to direct sunlight � Humid or poorly ventilated places � Extremely hot or cold places � Places subject to vibration � Dusty places � Places exposed to soot, steam or heat (in kitchens, etc.)
Cleaning the player
Normally, wipe the player with a soft cloth. For tough dirt, apply some neutral detergent diluted in 5 to 6 parts water to a soft cloth, wring out thoroughly, wipe off the dirt, then wipe again with a dry cloth. Note that getting alcohol, thinner, benzene or insecticide on the player could cause the print and coating to peel off. Also, avoid leaving rubber or vinyl products in contact with the player for long periods of time, as this could damage the cabinet. When using chemical-impregnated wipes, etc., read the wipe�s cautions carefully. Unplug the power cord from the power outlet when cleaning the player.
� Do not place objects on top
Do not place objects on top of the player.
� Do not obstruct the ventilation holes
Do not use the player on a shaggy rug, bed, or sofa, and do not cover the player with a cloth, etc. Doing so will prevent heat dissipation and could lead to damage.
Caution for when the unit is installed in a rack with a glass door
Do not press the � OPEN/CLOSE on the remote control to open the disc tray while the glass door is closed. The door will hamper the movement of the disc tray, and the unit could be damaged.
� Keep away from heat
Do not place the player on top of an amplifier or other device generating heat. When installing in a rack, to avoid the heat generated by the amplifier and other devices, place it on a shelf below the amplifier whenever possible.
Cleaning the pickup lens
The player�s lens should not become dirty in normal use, but if for some reason it should malfunction due to dust or dirt, consult your nearest Pioneer-authorized service center. Although lens cleaners for players are commercially available, we advise against using them since some may damage the lens.
Turn the power off when not using the player
Depending on the conditions of the TV broadcast signals, striped patterns may appear on the screen when the TV is turned on while the player�s power is turned on. This is not a malfunction with the player or TV. If this happens, turn the player�s power off. In the same way, noise may be heard in the sound of a radio.
58
En
