Inicio >>
PIONEER >>
BDP-HD50-K/KUC Manual de Servicio
0 artículo(s) en Su carrito
Opiniones de los clientes
No hay comentarios de productos.
TEXT_PDF_SNIPPET
5
6
7
8
7. DISASSEMBLY
Note 1: Do NOT look directly into the pickup lens. The laser beam may cause eye injury. Note 2: Even if the unit shown in the photos and illustrations in this manual may differ from your product, the procedures described here are common. Note 3: For the performing the diagnosis shown below, the following jigs for service are required. � GGF1529 : Emerqency tray ejection rod. � GGF1533 : BB Extension board � GGD1437 : BB Extension cable
A
Diagnosis of PCB's
1 Bonnet Case and Tray Panel
1 2 3 4 3 6 7
Remove the Bonnet Case by removing the eight screws. Press the Press the Press the Press the STANDBY/ON button to turn on the power. OPEN/CLOSE button to open the Tray. OPEN/CLOSE button to close the Tray. STANDBY/ON button to turn off the power.
B
Remove the Tray Panel.
Pull out the Power cord.
Tray
4
C
3
5
Tray Panel
26 3
How to open the Tray when the power cannot be on
D
1
Insert GGF1529 into bore as shown in the following figure. If the Tray pops out a little, fully pull it out by hand. Tray Tray open