Install the Camera Cover. 1
Put the camera cover over the main unit and hook the 2 tabs of the camera cover to each hole in the plate.
Hole
2
Fasten the camera cover by turning it to the right.
3
Attach the 2 caps to lock the cover to the mounting bracket of the camera.
Note
Tab Confirm that the 2 tabs are fit to each hole in the plate by watching through the openings. After the installation, dust, dirt or insects may get into the camera cover. Remove them by regularly removing the camera cover.
I Removing the Camera Cover Insert a flat head screw driver into the groove and remove the caps, this will unlock the camera cover from the mounting bracket of the camera. Groove
I Wiring Without Making Holes in the Ceiling Remove the notch from the camera cover and pass the wires through the hole.
Dimension (WHD) Specifications About 169 mm (6 5/8 inches) � 154 mm (6 1/16 inches) � 169 mm (6 5/8 inches)
