PHILIPS AZ2030/16
Manual de Usuario

DIGITAL TUNER
GENERAL INFORMATION General maintenance � Do not expose the set, batteries, CDs or cassettes to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. � To clean the set, use a soft, slightly dampened chamois leather. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing. Safety information � Place the set on a hard and flat surface so that the system does not tilt. Make sure there is adequate ventilation to prevent the system from overheating. � The mechanical parts of the set contain self-lubricating bearings and must not be oiled or lubricated. TUNING TO RADIO STATIONS 1. Select TUNER source. � is displayed briefly and then the radio station frequency, waveband and, if programmed, a preset number is shown. 2. Press BAND once or more to select your waveband. 3. Press SEARCH � or § (for AZ2035 model only: or on the remote control TUNING � or §) and release when the frequency in the display starts running. � The tuner automatically tunes to a station of sufficient reception. Display shows during automatic tuning. � If a FM station is received in stereo, STEREO is shown. 4. Repeat step 3 if necessary until you find the desired station. � To tune to a weak station, press SEARCH � or § briefly and repeatedly until you have found optimal reception.
AM

BASS REF

DIGEITPAL T L XS
EAKE R

To improve radio reception � For FM, pull out the telescopic aerial. Incline and turn the aerial. Reduce its length if the signal is too strong (very close to a transmitter). � For MW (AM/LW), the set is provided with a built-in aerial so the telescopic aerial is not needed. Direct the aerial by turning the whole set.

BATT LOW

AZ 2030-2035/17
7

English