PHILIPS AZ1024/05
Manual de Usuario

Az102_ 05_Eng 2007.8.28 11:41 Page 1

AZ102C AZ102N Important notes for users in the U.K. CD Soundmachine English Controls/Power Supply AZ102S Congratulations on your purchase and CAUTION 1

Register your product and get support at Mains plug Visible and invisible laser radiation.
This apparatus is fitted with an approved 13 Amp plug.To change a fuse in this type of If the cover is open, do not look at To fully benefit from the support that plug proceed as follows: www.philips.com/welcome Philips offers, register your product at the beam. 1. Remove fuse cover and fuse. the risk of getting an electric shock. 2. Fix new fuse which should be a BS1362 3 Amp, A.S.T.A. or BSI approved type. Supplied Accessories
� AC power cord

welcome to Philips!

www.philips.com/welcome. High voltage! Do not open.You run

The machine does not contain any user-serviceable parts. User Manual

Modification of the product could 3. Refit the fuse cover. result in hazardous radiation of EMC or other unsafe operation. 8 If the fitted plug is not suitable for your socket outlets, it should be cut off and an Top/front panels (See 1)

appropriate fitted in its place. If the mains plug contains fuse, this should have a 1 VOLUME � adjusts volume level. Use of controls adjustments or
2 SHUFFLE � plays all tracks in random order value 3 Amp. If plug without a is used, fuse at the distribution board performance of precedures other
DYNAMIC BASS BOOST

should not be greater than 3 Amp. than herein may result in unsafe

interference requirements of the

4 2 ; � starts or pause CD playback Note:The severed plug must be disposed of to avoid a possible shock hazard should it This set complies with the radio

CD program/entire CD.

operation. 3 REPEAT � repeats a track/

Power Supply
Whenever convenient, use the power supply

§ � � selects the next/previous track be inserted into a 13 Amp socket elsewhere. � searches forwards/backwards (press and hold the button) within the current track How to connect a plug

European Union.

The wires in mains lead are coloured with the following code: blue = neutral (N),

brown = live (L). As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows:

� Connect the brown wire to the terminal marked L or coloured red. coloured (or green and yellow). Before replacing plug cover, make certain that cord grip is clamped over the
VOLUME TUNING

6 LIFT TO OPEN � opens/closes the CD 0

program and wall outlet before inserting batteries. � Connect the blue wire to the terminal marked N or coloured black.

9 � stops CD playback; cord if you want to conserve battery life. � erases a CD program Make sure you remove plug from set 5 PROG � programs tracks and reviews the

7 TUNING � tunes to radio stations 1 Open the battery door and insert 6 batteries, @ 8 Display � shows the CD functions

door. Batteries (not included)

� Do not connect either wire to earth terminal in the plug, marked E (or e) or

type R-14, UM-2 or C-cells, (preferably

7 the "+" and "�" symbols inside the compartment.
2)and1U.K.theinCopyright
C S O U D M AC H I E A Z 1 0 2 N

alkaline) with the correct polarity as indicated by sheath of the lead not simply over the two wires.

1
switchoffpower�6
OPE

Back panel (See

9 Source selector: CD, FM, MW, OFF batteries are firmly and correctly in place.The Recording playback of material may require consent. See Copyright Act 1956 and
N

2 Replace battery door, making sure the

set is now ready to operate. The Performer�s Protection Acts 1958 to 1972. � selects CD or radio source of sound

H U G
F F O

S

reception.FMimproves-antennaTelescopic02 properly.ofdisposedbeshouldthey5
E P L R

LI FT

T

Batteries contain chemical substances, so
O

R EP
A T E

4 � Incorrect use of batteries can cause electrolyte

! AC MAINS~ inlet for power cord. 3

@ DBB � turns the bass enhancement on/off. leakage and will corrode the compartment or

� Do not mix battery types: e.g. alkaline with # LINE-IN � inlet for external audio source.

cause the batteries to burst:

carbon zinc. Only use batteries of the same type

Bottom panel for the set.

� When inserting new batteries, do not try to mix

old batteries with the new ones. Battery door � Press on the arrow and

push insert 6 x 1.5V R-14/ UM-2/ C� Remove batteries if the set is not to be used cells for a long time.

Power Supply General Operation / Tuner Meet Philips at the Internet
3 7 Using AC power http://www.philips.com 2

General operation

WARNING: Always check you have

Switching on off and selecting the completely switched off the set, before function you change or disconnect power supply.

To select your sound source, adjust 1 Check if the power voltage, as shown on

dealer or service center.
ON FM MW OFF

selector to OFF position.
BAND DBB

type plate located on the Source selector to: CD, FM or MW. bottom of the set, corresponds to your local power supply. If it does not, consult your

2 To switch off set, adjust the Source

4 8 @ 2 Connect the power cord to the AC

MAINS~ inlet the wall socket.The set is Adjusting volume and sound

$ Radio reception
AZ102C socket to protect your set during heavy AZ102N 5 thunderstorms. Children could seriously injure AZ102S 2 Turn TUNING to tune to a station.

W

!
the AC power plug can be easily reached.

Adjust the sound with the VOLUME and now connected and ready for use. DBB controls. 3 To switch set off completely, withdraw the

power cord from the wall socket.

4 Install unit near the AC outlet and where

� Disconnect power cord from the wall MW.
PR OG still be live if only the connector is removed

1 Adjust the Source selector to FM or

themselves as free end of the cable may

from the MAINS socket at the back of the unit. Helpful hints: The type plate is located on the

To improve radio reception

bottom of the set. � For FM, extend, incline and turn the

6 x R14 � UM-2 � C-CELLS

telescopic antenna for best reception. Reduce CLASS 1 � To avoid unnecessary energy consumption,

LASER PRODUCT Helpful hints: its length if the signal is too strong.

� For MW, the set uses a built-in antenna.

X

always adjust the Source selector to OFF Direct this antenna for best reception by after using the set. turning the whole set.
MW FM OFF CD

6

9
LINE-IN

#

ALL

Printed in China PDCC-ZC-0735