|
Usuarios conectados
Actualmente hay 5814 visitantes online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
Az102_ 05_Eng 2007.8.28 11:41 Page 1
AZ102C AZ102N Important notes for users in the U.K. CD Soundmachine English Controls/Power Supply AZ102S Congratulations on your purchase and CAUTION 1
Register your product and get support at Mains plug Visible and invisible laser radiation.
This apparatus is fitted with an approved 13 Amp plug.To change a fuse in this type of If the cover is open, do not look at To fully benefit from the support that plug proceed as follows: www.philips.com/welcome Philips offers, register your product at the beam. 1. Remove fuse cover and fuse. the risk of getting an electric shock. 2. Fix new fuse which should be a BS1362 3 Amp, A.S.T.A. or BSI approved type. Supplied Accessories
� AC power cord
welcome to Philips!
www.philips.com/welcome. High voltage! Do not open.You run
The machine does not contain any user-serviceable parts. User Manual
Modification of the product could 3. Refit the fuse cover. result in hazardous radiation of EMC or other unsafe operation. 8 If the fitted plug is not suitable for your socket outlets, it should be cut off and an Top/front panels (See 1)
appropriate fitted in its place. If the mains plug contains fuse, this should have a 1 VOLUME � adjusts volume level. Use of controls adjustments or
2 SHUFFLE � plays all tracks in random order value 3 Amp. If plug without a is used, fuse at the distribution board performance of precedures other
DYNAMIC BASS BOOST
should not be greater than 3 Amp. than herein may result in unsafe
interference requirements of the
4 2 ; � starts or pause CD playback Note:The severed plug must be disposed of to avoid a possible shock hazard should it This set complies with the radio
CD program/entire CD.
operation. 3 REPEAT � repeats a track/
Power Supply
Whenever convenient, use the power supply
§ � � selects the next/previous track be inserted into a 13 Amp socket elsewhere. � searches forwards/backwards (press and hold the button) within the current track How to connect a plug
European Union.
The wires in mains lead are coloured with the following code: blue = neutral (N),
brown = live (L). As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows:
� Connect the brown wire to the terminal marked L or coloured red. coloured (or green and yellow). Before replacing plug cover, make certain that cord grip is clamped over the
VOLUME TUNING
6 LIFT TO OPEN � opens/closes the CD 0
program and wall outlet before inserting batteries. � Connect the blue wire to the terminal marked N or coloured black.
9 � stops CD playback; cord if you want to conserve battery life. � erases a CD program Make sure you remove plug from set 5 PROG � programs tracks and reviews the
7 TUNING � tunes to radio stations 1 Open the battery door and insert 6 batteries, @ 8 Display � shows the CD functions
door. Batteries (not included)
� Do not connect either wire to earth terminal in the plug, marked E (or e) or
type R-14, UM-2 or C-cells, (preferably
7 the "+" and "�" symbols inside the compartment.
2)and1U.K.theinCopyright
C S O U D M AC H I E A Z 1 0 2 N
alkaline) with the correct polarity as indicated by sheath of the lead not simply over the two wires.
1
switchoffpower�6
OPE
Back panel (See
9 Source selector: CD, FM, MW, OFF batteries are firmly and correctly in place.The Recording playback of material may require consent. See Copyright Act 1956 and
N
2 Replace battery door, making sure the
set is now ready to operate. The Performer�s Protection Acts 1958 to 1972. � selects CD or radio source of sound
H U G
F F O
S
reception.FMimproves-antennaTelescopic02 properly.ofdisposedbeshouldthey5
E P L R
LI FT
T
Batteries contain chemical substances, so
O
R EP
A T E
4 � Incorrect use of batteries can cause electrolyte
! AC MAINS~ inlet for power cord. 3
@ DBB � turns the bass enhancement on/off. leakage and will corrode the compartment or
� Do not mix battery types: e.g. alkaline with # LINE-IN � inlet for external audio source.
cause the batteries to burst:
carbon zinc. Only use batteries of the same type
Bottom panel for the set.
� When inserting new batteries, do not try to mix
old batteries with the new ones. Battery door � Press on the arrow and
push insert 6 x 1.5V R-14/ UM-2/ C� Remove batteries if the set is not to be used cells for a long time.
Power Supply General Operation / Tuner Meet Philips at the Internet
3 7 Using AC power http://www.philips.com 2
General operation
WARNING: Always check you have
Switching on off and selecting the completely switched off the set, before function you change or disconnect power supply.
To select your sound source, adjust 1 Check if the power voltage, as shown on
dealer or service center.
ON FM MW OFF
selector to OFF position.
BAND DBB
type plate located on the Source selector to: CD, FM or MW. bottom of the set, corresponds to your local power supply. If it does not, consult your
2 To switch off set, adjust the Source
4 8 @ 2 Connect the power cord to the AC
MAINS~ inlet the wall socket.The set is Adjusting volume and sound
$ Radio reception
AZ102C socket to protect your set during heavy AZ102N 5 thunderstorms. Children could seriously injure AZ102S 2 Turn TUNING to tune to a station.
W
!
the AC power plug can be easily reached.
Adjust the sound with the VOLUME and now connected and ready for use. DBB controls. 3 To switch set off completely, withdraw the
power cord from the wall socket.
4 Install unit near the AC outlet and where
� Disconnect power cord from the wall MW.
PR OG still be live if only the connector is removed
1 Adjust the Source selector to FM or
themselves as free end of the cable may
from the MAINS socket at the back of the unit. Helpful hints: The type plate is located on the
To improve radio reception
bottom of the set. � For FM, extend, incline and turn the
6 x R14 � UM-2 � C-CELLS
telescopic antenna for best reception. Reduce CLASS 1 � To avoid unnecessary energy consumption,
LASER PRODUCT Helpful hints: its length if the signal is too strong.
� For MW, the set uses a built-in antenna.
X
always adjust the Source selector to OFF Direct this antenna for best reception by after using the set. turning the whole set.
MW FM OFF CD
6
9
LINE-IN
#
ALL
Printed in China PDCC-ZC-0735
|
|
|
> |
|