USING THE REMOTE CONTROL
LOADING BATTERIES Use two size-AAA (R03) batteries.
1 Remove the battery cover at the back
{
of the remote control.
|
2 Insert
batteries in the compartment, making sure the ± and � polarities are correctly aligned. � Lines will be indicated on the display when batteries are properly installed. the battery cover.
|
{
3 Reinstall
Remote control cover
4 Press the RESET button using a thin stick.
NOTES:
� The battery life is approximately one year in normal use. � When you replace the batteries, always change both batteries, and make sure they are the same type. � If the remote control does not operate properly after replacing the batteries, press the RESET button using a thin stick. � If you will not be using the unit for a long time, remove the batteries from the remote control.
ENGLISH
HOW TO USE THE REMOTE CONTROL
Point the remote control towards the unit�s signal receiver window and press the desired button. The unit generates a beep when it receives the signal.
� Make sure there is no curtain or other object between the remote control and the unit. � The remote control can send signals from up to 7 metres away.
CAUTION
� Do not allow the signal receiver window to receive strong direct sunlight, since it can adversely affect its operation. If the signal receiver window is exposed to direct sunlight, close a curtain to block the light. � Using a fluorescent lamp with a quick starter in the same room may interfere with transmission of the signal. � The unit can be affected by signals transmitted from the remote control of a television, VCR or other equipment used in the same room. � Do not leave the remote control in direct sunlight or near a heater. Also, protect the unit and remote control from moisture and shock which can discolour or damage them.
