PANASONIC AWCB400N
Manual de Usuario

Parts and their function
A PED dial
This enables the total pedestal of the cameras to be set. When exercising control over the AW-E350, AW-E650, AW-E655 or AW-E750, the change of setting value in the dial�s setting can be switched from �large� to �small� or vice versa by pressing the CONT dial.

F INCOM jack
The INCOM (inter-communication) headset is connected here.

G LEVEL control
Use this to adjust the volume of the headset�s receiver.

B IRIS [AUTO/MANU/LOCK] button
Use this to select the method for adjusting the lens iris of the cameras selected by the CAM CONTROL buttons. Each time it is pressed, the setting is switched in the sequence of AUTO, MANU and LOCK. AUTO: The cameras automatically adjust the lens iris in accordance with the light quantity, and the button lamp lights. MANU: The lens iris is adjusted manually using the (I) IRIS dial. At this setting, the button lamp is off. LOCK: The lens iris is locked at the manually adjusted setting. It cannot be adjusted even by turning the (I) IRIS dial. When the (I) IRIS dial is turned, the button lamp flashes to indicate that the lens iris cannot be adjusted. When the ROP is connected to the pan/tilt control panel, the lens iris control can be set to �From pan/tilt control panel only�, �From ROP only� or �From both�, depending on the setting selected by the pan/tilt control panel. For further details, refer to the instruction manual of the pan/tilt control panel.

H CALL button
When this button is pressed, the buzzer of the connected controller sounds, and the button lamp lights.

I IRIS dial
The lens iris can be adjusted by turning this dial while the (B) IRIS [AUTO/MANU/LOCK] button is set to MANU. The iris is opened by turning the dial clockwise and stopped by turning it counterclockwise. By pressing the (C) CONT dial, the response speed can be switched from �fast� to �slow� or vice versa.

J FAST/SLOW lamp
When the response speed of the (I) IRIS dial is at �fast�, this lamp lights up; when it is at �slow�, the lamp is off.

C CONT dial
Use this for menu setting operations.

D OPERATE lamp
When the (E) OPERATE switch is at ON, this lamp lights up green; when it is at OFF, the lamp is off.

E OPERATE [OFF/ON] switch
Camera control is enabled by setting this switch to ON.

Note
When the ROP is connected to the pan/tilt control panel, camera control is not possible unless the OPERATE switch on the pan/tilt control panel is set to ON.

8