|
|
|
Usuarios conectados
Actualmente hay 6029 visitantes y
14 usuarios online. |
|
Productos
|
|
Información
|
|
Destacado
|
|
|
 |
|
|
No hay comentarios de productos.
Quick Setup
Getting Started
Getting Started
These quick setup pages will provide you, in three easy steps, with the basic information you need to begin using your new television right away. If you have questions, or for more detailed information on any of these steps, please consult other sections of this manual.
Step 1 � The Remote Control
Before you can operate your remote control, you first need to install the batteries (included). Lift and pull the latch on the back of the remote control to open. Insert two batteries (included) carefully noting the �+� and ��� markings, placing the ��� end in the unit first. Snap the cover back into place. When you change the batteries, try to complete the task within three minutes. If you take longer than three minutes, the remote control codes for your VCR, DVD, and/or cable box/satellite receiver may have to be reset. See pages 18 - 21.
�� ���� ��� ���
�����
�����
�������
� � �
����
� � � �
����
� � �
�������
����� �����
�����
����� ������
Key Feature Buttons
The four key feature buttons at the center of the remote can be used for basic operation of the television. The top and bottom buttons will scan forward and back through the available channels. To move rapidly through the channels using JVC�s Hyperscan feature, press and hold CH+ or CH�. The channels will zip by at a rate of five channels per second. The right and left buttons will turn the volume up or down. These buttons are also marked with four arrows and are used with JVC�s onscreen menu system. To use the onscreen menus, press the MENU button.
������� ���
������
����
�� � ��� � ��� �
�� �
����
��� ������� �������
����
Note: Illustration of remote ���� ���� ����� ������ control RM-C1259G
��� ��� ���� ���� �� �����
����������
�����������
10
���������
��
|
|
|
> |
|
