SHARP AR-PB9M
Manual de Servicio

AR-PB9M 3) Turn on your computer and start Windows. Note: Before installing the printer driver, be sure to close all other applications which may be open. 4) When using Windows 95 on a personal computer with plug & play*, the �Update Device Driver Wizard� window will appear. Insert the installation CD-ROM into the CD-ROM drive. Click the Next button and follow the on-screen instructions. If the �Copying Files� window appears during this operation, enter R:\ (if the CD-ROM is designated as drive R), click the OK button and follow the on-screen instructions.

B. Windows 98:
With both the computer and the printer turned off, connect the printer to the computer with either a parallel or a USB interface cable. 1) Load paper into the paper tray of the printer. For instructions on loading paper, see the section LOADING COPY PAPER found in the copier operation manual. 2) Turn on the printer. 3) Turn on your computer and start Windows. When using the USB interface: G Connect your personal computer and the printer using a USB interface cable if you have not already done so. (For information about connecting the USB interface cable) G When the �Add New Hardware Wizard� window appears, insert the installation CD-ROM, click the Next button, follow the on-screen instructions, and finally click the Finish button.

G If you use Windows 95 and the �New Hardware Found� window will appear, select Driver from Disk Provided by Hardware Manufacturer and then click the OK button. Proceed to step 6. G If you use Windows 95 and the screen shown above or the �New Hardware Found� window does not appear, proceed to step 5. G If you use Windows NT 4.0, proceed to step 5. * Plug & play This feature is effective if both the computer and peripheral equipment are equipped with IEEE 1284 compliant parallel interface. Note: The screen displayed depends on the version of Windows you are using. 5) Insert the installation CD-ROM into the CD-ROM drive. Click the Start button and select Run. When the screen shown below appears, type R:\SETUP (if the CD-ROM is designated as drive R) and click the OK button. Follow the on-screen instructions.

Note: Before installing the printer driver, be sure to close all other applications which may be open. 4) When using Windows 98 on a personal computer with plug & play*, the �Add New Hardware Wizard� window will appear. Click the Next button and follow the on-screen instructions. G If the �Add New Hardware Wizard� window does not appear, proceed to step 8.

6) The �Install From Disk� window will appear. Insert the installation CD-ROM into the CD-ROM drive. Type R:\ (if the CD-ROM is designated as drive R) and click the OK button. Follow the on-screen instructions. 5) Select Search for the best driver for your device and click the Next button. 6) Insert the installation CD-ROM into the CD-ROM drive. (If you are using the USB interface, confirm that the installation CDROM is in the CD-ROM drive.) Select the CD-ROM drive and click the Next button.

Note: If you have any problem with the test print, check the symptoms and solutions. Print the test page again after resolving the problem.

3�4