AR-PB9 5) Attach the PCL PWB. G While ensuring that the connector of the PCL PWB is securely connected to that of the copier, attach the PCL PWB to the PWB cover with seven screws (M3 � 6) and connect the relay harness connector. 8) Attach the PWB cover. G Attach the supplied PWB cover with five screws (M3 � 6).
M3X6
M3X6
M3X6
M3X6
M3X6 M3X6
6) Attach the PCL harness. G Attach the supplied PCL harness to the PCL PWB, then pass it through the square hole of the PWB holder, and connect it to the PCL interface PWB. Note: Be careful about the direction of the blue lines.
Blue lines
9) Attach the PWB cover lid 2. G Hang the pawls of the supplied PWB cover lid 2 on the PWB cover and attach the PWB cover lid 2 with two screws (M3 � 6).
1
2
M3X6 M3X6
Pawls
7) Attach the PWB cover. (1) Fit the upper part of the PWB cover lid to the upper screw that has been loosened in step 3 above. (2) While rotating the lower part of the PWB cover lid clockwise, fit it to the lower screw. (3) Tighten the upper and lower screws to secure the cover lid.
