WHIRLPOOL ARG 484/WP/01
Manual de Usuario

3gb33001.fm5 Page 49 Monday, August 20, 2001 3:48 PM

Removing the ice maker bin Remove, empty, and clean the bin: � if the ice dispenser has not been or will not be used for a week or more; � if a power failure causes ice in the bin to melt and freeze together; � if the ice dispenser is not used regularly.

To remove the bin 1.Pull the covering panel out from the bottom and slide it to the rear. 2.Lift the signal arm to the OFF position. Ice can still be dispensed, but no more will be made. 3.Lift the front of the bin and pull it out. 4.Empty the bin. Use warm or lukewarm water to melt the ice if necessary. Do not use sharp tools to break up the ice in the bin. This can damage the bin and the dispenser mechanism. 5.Wash following the instructions given under chapter �Maintenance and Cleaning�. Rinse well. Do not use abrasive cleaners or solvents. 6.When putting the bin back, make sure it is pushed all the way in. Push the signal arm down to the ON position to restart ice cubes production.

NOTE: Do not turn the ice maker on until it is connected to the water supply. � It is normal for ice cubes to be attached by a corner. They will break apart easily. � The ice maker will not operate until the freezer compartment is cold enough to make ice. This can take overnight. � If ice is not being made fast enough and more ice is needed, set the refrigerator thermostat on a higher number. Wait a day and, if necessary, set the freezer compartment thermostat knob on �4/5.� � Good water quality is important for good ice quality. Water softener chemicals such as salt can damage the ice maker and lead to poor quality ice.

49