SHARP AR-FX2
Manual de Servicio

AR-FX2 Number 138 Program Name IMAGE MEM. PRINT (LINE ERROR) SETTING Soft SW setup SW1-7 SW19-7 SW47-1 SW48-1 SW49-1 SW50-1 SW30-7 SW33-1 SW32-6 No soft SW SW46-5 SW1-1 � 2 SW8-1 SW3-1 � 5 No soft SW � � � � � 8, 5, 6, 5, 6 Function Set to control whether to print the first part of the original on the transaction report when there is an error. Note

139

AUTO LISTING SETTING

Set to have a listing of fax activity automatically printed at a certain time.

140 141 142 143 144 151 152 153 161

PRINT STATION # IN RCVD DATA SETTING PAGE COUNTER PRINT SETTING INDEX PRINT DATE AND TIME SETTING DAYLIGHT SAVING TIME SETTING RES. PRIORITY SETTING SEND MODE EXPOSURE SETTING OPTIONAL SETTING LIST PRINT

Set to choose where to print the date, your name, and your fax number on faxes you send. Set to print page numbers on faxes you send. Set to print an index mark on the top of received faxes. Use to set the date and time of the internal clock. Set the fax machine to automatically make time changes during the year. Set to select the resolution of transmitted faxes (for example, STANDARD, FINE, SUPER FINE, ULTRA FINE). Set to choose whether direct mode or memory sending mode is the default in the initial state. Set to select the exposure of transmitted faxes (for example, LIGHT, MEDIUM, DARK). Set to choose whether to print a list of settings made in user programs.

2. How to use user programs
You cannot change user programs during a fax transmission or reception. 1) Select fax mode. If the copier mode indicator is lit, press the COPY/FAX key.

2) Press and hold the light (

) key for more than 5 seconds.

Canceling: If you make a mistake entering the user program number, press the CLEAR key and enter the number again. 4) Follow the instructions that start on the next page for specific information about setting user programs. Canceling: When setting using programs, if you make a mistake entering a number or time using the numeric keys, open the rapid key overlay, press the CLEAR key, and enter the numbers again. When setting user programs, the current settings and options are shown on the display panel. When you want to exit from the middle of a user program, press the light ( ) key. When changing between screens, use the arrow keys as follows.

The following message is displayed.

Example: P102 DIAL MODE SETTING DIAL MODE 1:TONE
Press the right arrow key ( ) Press the left arrow key ( )

USER PROGRAM ENTER PRG. #=
3) Enter the desired user program number (3-digit) using the numeric keys, then press the START key. The user program number and name are displayed. Instead of entering the user program number, you can also press the left arrow key ( ) or right arrow key ( ) to select the user program.

DIAL MODE 2:PULSE
5) When you are finished setting user programs, press the light ( key. )

7�2