|
No hay comentarios de productos.
AM-300DE
6. Loading paper
7) If you installed a new toner cartridge, press (this will reset the toner counter to zero). to select YES You can load approximately 250 sheets of A4 paper (80 g/cm2) in the paper tray. Caution! Do not use the blank side of paper that has already been printed on. 1) Remove the output tray.
NEW TONER? OK: PRESS START
� If you temporarily removed and then replaced an old toner cartridge for maintenance or other reason, press to continue ,
using the previous toner count. (Note: Be sure to press
or the machine will not alert you when the toner cartridge is out of toner.) 8) Press .
2) Insert a stack of paper into the tray, print side up. � Important! The stack of paper must not be higher than the paper height line on the paper tray.
9) If you installed a new drum cartridge, reset the drum counter as explained below.
4. Resetting the drum counter
Each time you install a new drum cartridge, follow the steps below to reset the drum counter to zero.
1
Press
MENU
and then
Z
or
A
Display:
LIFE
Paper height line
repeatedly until the display at right appears.
2
Press
.
CLEAR: START KEY DRUM COUNTER
3) Squeeze the sides of the paper guide as shown and slide it to the slot for the length of the paper you are loading (A4).
3 4
Press Press
. repeatedly to exit.
1: LIFE COUNTER
5. Manually resetting the toner counter
When a new toner cartridge is installed, the toner counter is reset in Step 7 on the previous page. The procedure below is normally not necessary; however, it can be used in the event that you need to reset the toner manually. 4) Replace the output tray.
Display:
1
Press
MENU
and then
Z
or
A
LIFE
repeatedly until the display at right appears.
2
Press
.
CLEAR: START KEY TONER COUNTER
3 4
Press
.
3: CLR DRUM COUNT
Press
repeatedly to exit.
1�8
|
