SHARP AM300
Manual de Servicio

AM-300DE
6. Loading paper
7) If you installed a new toner cartridge, press (this will reset the toner counter to zero). to select YES You can load approximately 250 sheets of A4 paper (80 g/cm2) in the paper tray. Caution! Do not use the blank side of paper that has already been printed on. 1) Remove the output tray.

NEW TONER? OK: PRESS START
� If you temporarily removed and then replaced an old toner cartridge for maintenance or other reason, press to continue ,

using the previous toner count. (Note: Be sure to press

or the machine will not alert you when the toner cartridge is out of toner.) 8) Press .

2) Insert a stack of paper into the tray, print side up. � Important! The stack of paper must not be higher than the paper height line on the paper tray.

9) If you installed a new drum cartridge, reset the drum counter as explained below.

4. Resetting the drum counter
Each time you install a new drum cartridge, follow the steps below to reset the drum counter to zero.

1

Press

MENU

and then

Z

or

A

Display:

LIFE

Paper height line

repeatedly until the display at right appears.

2

Press

.

CLEAR: START KEY DRUM COUNTER

3) Squeeze the sides of the paper guide as shown and slide it to the slot for the length of the paper you are loading (A4).

3 4

Press Press

. repeatedly to exit.

1: LIFE COUNTER

5. Manually resetting the toner counter
When a new toner cartridge is installed, the toner counter is reset in Step 7 on the previous page. The procedure below is normally not necessary; however, it can be used in the event that you need to reset the toner manually. 4) Replace the output tray.

Display:

1

Press

MENU

and then

Z

or

A

LIFE

repeatedly until the display at right appears.

2

Press

.

CLEAR: START KEY TONER COUNTER

3 4

Press

.

3: CLR DRUM COUNT

Press

repeatedly to exit.

1�8