WHIRLPOOL AKP 300/IX/02
Manual de Usuario

Hob Attention: to install the hob on other surfaces than wood (e.g. plastic, ceramic, marble, stone, etc.) remember to ask After Sales Service for the fixing plates (Fig. 7-9). � The hob must be fitted in a worktop with a minimum thickness of 20 mm and a maximum of 50 mm. � There must be nothing between the hob and the oven (e.g. cross rails, insulating material, etc.). � An adjacent column unit must be installed at least 100 mm from the edge of the hob (Fig. 5). � Cut an opening in the worktop of the dimensions shown on the Product Description Sheet provided with the worktop. � We recommend you seal the internal edges of the worktop with wood glue or silicone. � If not already in place, apply the supplied seal to the hob, after cleaning the adhesive surface thoroughly. Conventional electric hob IMPORTANT: Remove any protective film before installing the hob. � If the worktop is made of wood, use the spring clips and screws provided. 1. Insert the 4 spring clips (B) (fig. 6) in their guides on the bottom of the hob. 2. Fit the hob into the worktop. � If the worktop is made of marble or other material (e.g. plastic, ceramic, marble, stone, etc.), the hob must be secured with special brackets (C) (Fig. 7), code 4819 310 18528, available at After Sales Service. 1. Fasten the brackets into the holes with the screws provided. 2. Fit the hob into the worktop.

5

6

7

17