|
|
|
Usuarios conectados
Actualmente hay 5765 visitantes online. |
|
Productos
|
|
Información
|
|
Destacado
|
|
|
 |
|
|
No hay comentarios de productos.
INSTALLATION Adjustment to different types of gas
If a different type of gas from the one indicated in the plate is used, the cooking hob must be adapted to it. 1. The gas nozzles must be changed by AfterSales Service or a qualified technician. Nozzles not supplied with the appliance must be ordered from After-Sales Service. 2. Connect the cooking hob to the gas shut-off valve by means of a pipe suitable for the type of gas used, in compliance with current local regulations. 3. Adjust the minimum setting of the taps. Note: when liquid petroleum gas is used (G 30/ G 31), the minimum gas setting screws must be tightened as far as they will go. Replacing the injectors (see table in enclosed product description sheet) 1. Remove grids . 2. Extract burners . 3. Using a socket spanner of the appropriate size, , unscrew the injector to be replaced.
a b c
d e
c
a b
-
4. Replace it with the injector suitable for the new type of gas. 5. Re-assemble the injector in . 6. For models equipped with a triple crown burner, proceed as shown in figure. x Remove the two screws followed by the cap then replace both injectors as previously described. Replace the cap , ensuring the seal is properly positioned before attempting to use the cooktop. 7. Before installing the cooktop, remember to affix the gas calibration plate supplied with the injectors in such a way that it covers the existing information relating to gas calibration.
d
f
g
d
g
Adjusting minimum gas setting of taps
To ensure that the minimum setting is correctly adjusted, remove knob and proceed as follows: x tighten (-) to reduce the height of the flame; x loosen (+) to increase the height of the flame. The adjustment must be performed with the tap in minimum gas setting position (small flame) .
e
58
|
|
|
> |
|
