PANASONIC AJD750
Manual de Usuario

<Front Panel Center Section>
PREROLL button This is used for feeding and cueing the tape for manual editing. When it is pressed, the tape travels to the preroll point where it stops. The preroll time can be set on-screen. When this button is pressed together with the IN or OUT button, the tape can be cued to the IN or OUT point entered. When the AUDIO ENTRY on the setup menu No.311 is set to 1, IN point has been entered at the point where the PREROLL button is pressed even if the IN point has not been entered. AUTO EDIT button Automatic editing is executed when this is pressed after an edit point has been entered. When the AUTO EDIT button is pressed though the IN point has not been entered, automatic editing is executed using the point at which the button was pressed as the IN point. PREVIEW/REVIEW buttons PREVIEW: When this is pressed after an edit point has been entered, the tape travels, editing is not performed, and the rehearsal can be activated on the screen connected to the recorder. If it is pressed when the IN point has not been entered, the point at which the button was pressed is entered as the IN point, and preview is executed accordingly. REVIEW: If this is pressed after a block has been edited, the now edited block can be played back and monitored on the screen connected to the recorder. IN/SET/OUT buttons When IN or OUT button is pressed together with the SET button, the IN or OUT point is entered. While an IN or OUT point is being entered, the lamp in the IN or OUT button corresponding to the point being entered lights. When this button is pressed after a point has been entered, the IN or OUT point value appears on the counter display. When the IN or OUT button is pressed together with the RESET button, the IN or OUT point entry is cleared. TRIM buttons These buttons are used to trim IN or OUT point finely. When the � or � button is pressed while the IN or OUT button is held down, the +� �� entered edit point can be trimmed in 1-frame increments. When the � button is pressed, +� the tape is advanced by one frame; when the � button is pressed, it is rewound by one �� frame. ASSEMBLE button This is pressed for assemble editing. The button is self-illuminating, and it is set ON (lamp lights) when it is pressed once and OFF (lamp goes off) when it is pressed again. INSERT buttons Press one of these five buttons to select the input signals to be edited during insert editing. The buttons are self-illuminating, and they are set ON (lamp lights) when they are pressed once and OFF (lamp goes off) when they are pressed again. Counter display This displays the TC and CTL count values, on-screen information and other messages.

-11-