PHILIPS AJ3980/05
Manual de Usuario

SLEEP TIMER / MAINTENANCE
SLEEP TIMER (see figure 7) About SLEEP TIMER This feature is a built-in timer device which enables the set to be automatically switched off during CD / radio playback, after a set period of time. There are three timer options: 60 , 30 and 15 minutes. Setting SLEEP TIMER 1. Press the SLEEP TIMER button rapidly once or more to select your timer options: 60 , 30 and 15 minutes. =The display will show SL: and the timer options briefly. = appears when the timer is active. 2. To cancel the timer, you can either press: � TIME/ALARM CD / RADIO OFF � REPEAT ALARM/ BRIGHTNESS CONTROL Maintenance General (see figure 8) � If you do not intend to use the set for a long time, withdraw the plug from the wall outlet. � Do not expose the set, to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. � To clean the set, use a soft, dry cloth. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the product�s surface. CD player and CD handling (see figure 9) � The lens of the CD player should never be touched! � Sudden changes in the surrounding temperature can cause condensation to form and the lens of your CD player to cloud over. Playing a CD is then not possible. Do not attempt to clean the lens but leave the set in a warm environment until the moisture evaporates. � Always shut the CD door to keep the CD compartment dust-free. To clean, dust the compartment with a soft dry cloth. � To clean the CD, wipe in a straight line from the centre towards the edge using a soft, lint-free cloth. Do not use cleaning agents as they may damage the disc. � Never write on a CD or attach any stickers to it.

TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
Continuous crackling/ hiss disturbance during MW(AM) broadcast � Electrical interference from TVs, computers, fluorescent lamps, etc. � Move set away from other electrical equipment The alarm does not function � Alarm mode not selected � See chapter on SETTING THE ALARM � Alarm time not set � See chapter on SETTING THE ALARM.

Important notes for users in the U.K.
Mains plug This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows: 1. Remove fuse cover and fuse. 2. Fix new fuse which should be a BS1362 5 Amp, A.S.T.A. or BSI approved type. 3. Refit the fuse cover. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp.

WARNING:
Do not open the set as there is a risk of electric shock! Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee.
No sound � Volume not adjusted � Adjust the VOLUME � Headphones are connected � Disconnect headphones No reaction to any operation of the bottons � Electrostatic discharge � Disconnect the set from the power supply and reconnect the set after 5 minutes. CD playback does not work � � � � � � � �

CAUTION
Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation.

Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere.
How to connect a plug The wires in the mains lead are coloured with the following code: blue = neutral (N), brown = live (L). � As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows: - Connect the blue wire to the terminal marked N or coloured black. - Connect the brown wire to the terminal marked L or coloured red. - Do not connect either wire to the earth terminal in the plug, marked E (or e) or coloured green (or green and yellow). Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not simply over the two wires. Copyright in the U.K. Recording and playback of material may require consent. See Copyright Act 1956 and The Performer�s Protection Acts 1958 to 1972.

CD badly scratched or dirty Replace/ clean CD Laser lens steamed up Wait until lens has adjusted to room temperature Laser lens dirty Clean lens by playing a CD lens cleaning disc CD-R(W) is non-finalized Use a finalized CD-R(W)

Environmental information
All unnecessary packaging material has been omitted. We have done our utmost to make the packaging easily separable into 2 materials: paper pulp, polyethylene. Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe local regulations on the disposal of packing materials and old equipment.

Occasional crackling sound during FM broadcast � Weak signal � Extend coil antenna fully

This product complies with the radio interference requirements of the European Union. The serial and production number are located on the bottom of the set.