RADIO You can use this set solely as a radio! 1 Adjust RADIO ON / OFF to ON to switch on the radio. 2 Select your waveband by adjusting the BAND switch. 3 Adjust TUNING to tune to your desired station. 4 Turn the VOL control to adjust the volume level. 5 Adjust RADIO ON / OFF to OFF to switch off the radio. To improve reception: FM: extend and position the pigtail for optimum reception. AM: uses a built-in aerial inside the set. Direct the aerial by adjusting the position of your set. SETTING THE CLOCK AND ALARM TIMES The time is displayed using the 24-hour clock IMPORTANT! To adjust the clock and alarm times accurately, always make sure you press the 7 or � buttons separately and not simultaneously. 1 Adjust the clock control to SET TIME or SET AL. 1 or SET AL. 2 to set the clock or alarm time respectively. 2 Press 7 or � repeatedly or hold down on the respective button to adjust the hours and minutes. 3 Release 7 or � when you reach the correct setting. 4 After you have set both the hour and minutes, adjust the clock control to CLOCK to run on clock time. SELECTING THE ALARM MODE GENERAL If you wish to use the alarm, you must first set the alarm time first. You can choose from two different alarm modes to wake you up: by radio or buzzer. � Select your choice of alarm mode by adjusting ALARM 1 or ALARM 2 to RADIO or BUZ. � The 2 buzzers are at a set volume and cannot be adjusted. BUZ on ALARM 1 is a low tone buzzer while BUZ on ALARM 2 is a high tone.
