TUNER 1 Press TUNER/AUX once to switch on the radio (FM only). � Display shows the radio frequency of the last selected waveband. Your preset station is also shown if you are listening to a preset. (See 2) 2 Adjust the sound using VOL+/-. 3 To select preset stations, press the respective PRESET button (1-5). TUNING TO RADIO STATIONS 1 Press and hold ¡1 / 2� until the frequency in the display starts changing. �Display shows �Scrh� during automatic tuning. �After the system tunes to a station of sufficient reception, display shows its frequency. � To tune to a weak station, press ¡1 / 2 � briefly and repeatedly until an optimal reception is found. To improve reception (FM): Extend and position the pigtail fully to obtain optimum reception. STORING AND USING PRESET STATIONS You can store up to 5 FM radio stations in the memory. 1 Tune to your desired station (see TUNING TO RADIO STATIONS). 2 To store a preset, hold down briefly on a PRESET button 1-5 until you hear a double beep. � Display shows the preset number of your station. 3 Repeat steps 1 and 2 to store your other stations. � You can overwrite a preset station by storing another frequency in its place. 4 Press a PRESET button 1-5 (or PRESET 4 / 3 on the remote control) to listen to a preset station. � To display clock time, press 2; on the set. USING THE ALARM GENERAL Two different alarm times can be set. This can be useful when you need to be woken up at a different time e.g. during the week and at the weekend, and you can set different wake-up modes: � tuner mode. � buzzer mode. The gentle wake buzzer alarm increases its beep tone frequency within seconds. � dock mode (only for Apple iPod and Philips GoGear SA9100 and SA9200)